The main changes in these two regulations compared with the former ones are listed below:
For RFID [Regulation No. (2024) 76]:
- 800MHz RFID band removed from its use.
- Specific 900MHz RFID band -divided into 3 different frequency ranges with different requirements- has been enabled for RFID.
- The spurious emission limit on some specific frequency has been modified (TX mode).
- New test item "Receiver blocking limit" added.
For UWB [Regulation No. (2024) 77]:
- The 7163-8812MHz band is enabled for its use by ultra-wideband (UWB) radio transmitting equipment -equipment with a transmit signal bandwidth (bandwidth -10dB) of not less than 500MHz-, mainly used in short-distance high-speed wireless data communication, positioning, ranging, perception and other fields.
- The remaining parts of the 5.925-10.6GHz band that were covered by the old regulation are now specified as band edge emission and their requirements will vary depending on the band segment (5.925-7.125GHz; 7.125-7.136GHz; 8.812-9GHz; 9-10.6GHz).
- UWB equipment is prohibited from being used within 1 km around radio astronomy observatories and on aircraft equipment (including unmanned aircraft).
- The spurious emission limit on some specific frequency has been modified (TX mode).
- The spurious emission for the general frequency range has been decreased (TX mode).
- The spurious emission for the general frequency range has been decreased (RX and IDLE modes).
The new RFID regulation will come into force on 1 November 2024, while the new UWB regulation will be on 1 August 2025. Existing regulations [RFID: Regulation No. (2007) 205 & UWB: Regulation No. (2008) 354] will be both withdrawn, allowing existing compliant equipment to apply for type-approval or its extension until these dates respectively. After the corresponding dates, only RFID/UWB equipment that complies with the new criteria will be type-approved, and already certified devices can continue to be used until they are removed from service.
For further information, please do not hesitate to contact us.
Original sources:
- MIIT - Regulation No (2024) 76.
- MIIT - Regulation No (2024) 77.
For RFID [Regulation No. (2024) 76]:
- 800MHz RFID band removed from its use.
- Specific 900MHz RFID band -divided into 3 different frequency ranges with different requirements- has been enabled for RFID.
- The spurious emission limit on some specific frequency has been modified (TX mode).
- New test item "Receiver blocking limit" added.
For UWB [Regulation No. (2024) 77]:
- The 7163-8812MHz band is enabled for its use by ultra-wideband (UWB) radio transmitting equipment -equipment with a transmit signal bandwidth (bandwidth -10dB) of not less than 500MHz-, mainly used in short-distance high-speed wireless data communication, positioning, ranging, perception and other fields.
- The remaining parts of the 5.925-10.6GHz band that were covered by the old regulation are now specified as band edge emission and their requirements will vary depending on the band segment (5.925-7.125GHz; 7.125-7.136GHz; 8.812-9GHz; 9-10.6GHz).
- UWB equipment is prohibited from being used within 1 km around radio astronomy observatories and on aircraft equipment (including unmanned aircraft).
- The spurious emission limit on some specific frequency has been modified (TX mode).
- The spurious emission for the general frequency range has been decreased (TX mode).
- The spurious emission for the general frequency range has been decreased (RX and IDLE modes).
The new RFID regulation will come into force on 1 November 2024, while the new UWB regulation will be on 1 August 2025. Existing regulations [RFID: Regulation No. (2007) 205 & UWB: Regulation No. (2008) 354] will be both withdrawn, allowing existing compliant equipment to apply for type-approval or its extension until these dates respectively. After the corresponding dates, only RFID/UWB equipment that complies with the new criteria will be type-approved, and already certified devices can continue to be used until they are removed from service.
For further information, please do not hesitate to contact us.
Original sources:
- MIIT - Regulation No (2024) 76.
- MIIT - Regulation No (2024) 77.
Eleos Compliance offer international RF, EMC, Safety and Green type approval services for radiocommunications products.
Eleos Compliance are a sustainable, values-based business combining extensive experience in the wireless homologation sector with outstanding project management.
For full support with your global market access requirements or regulatory intelligence needs please contact us at enquiries@eleoscompliance.com
